These guys are local to my state and a shop down the road carries their bullets.
https://www.cheycastbullets.com/40cal_c_102.html
Is this a good choice for 10mm?
I'm guessing a flat nose is preferable for woods carry. Why the round nose? Would it be effective on a black bear?
These will be shot in my new M&P 4.6" 10mm.
Sent from my Pixel 3 using Tapatalk
They should work well being coated bullets. For bear a Wide Flat Nose would tend to be a better choice at cutting a better entrance wound.
Quote from: The_Shadow on December 05 2022 05:51:54 PM MST
They should work well being coated bullets. For bear a Wide Flat Nose would tend to be a better choice at cutting a better entrance wound.
Thanks!
If there is a specific bullet you like, would you mind sharing it?
Thanks, their prices are similar to Missouri Bullet Company's stuff, or maybe just a tad higher
Quote from: Kenk on December 05 2022 06:54:09 PM MST
Thanks, their prices are similar to Missouri Bullet Company's stuff, or maybe just a tad higher
I see they make a coated 200 grain with a flat face. These should feed OK in the M&P?
Its such a pain to order a big box of bullets that don't feed.
Sent from my Pixel 3 using Tapatalk
It?s a true fact, the good news is, they can always be melted down and reused 😀
Quote from: czgunner on December 06 2022 08:21:36 PM MST
I see they make a coated 200 grain with a flat face. These should feed OK in the M&P?
Its such a pain to order a big box of bullets that don't feed.
Sent from my Pixel 3 using Tapatalk
IIRC, With the flat heads, you may have to watch the overall length re tipping angle into chamber