Text only | Text with Images

10mm-Auto

General => Gunsmithing => Topic started by: Intercooler on August 12 2013 06:04:41 PM MDT

Title: Dan Wesson Razorback flat bottom block install round 2
Post by: Intercooler on August 12 2013 06:04:41 PM MDT
   I must have made an error this time telling EGW to send the wrong one... AGAIN!  >:D

Old on bottom and new on the top. I decided to just go for it instead of sending it back.
(http://i236.photobucket.com/albums/ff100/Intercooler2/20130812_172656_zpse711b8a1.jpg)

Old on bottom and new on the top.
(http://i236.photobucket.com/albums/ff100/Intercooler2/20130812_172746_zps5daa2410.jpg)

The stop was a little wide for the channel left to right and had to be trimmed down. Took more time than expected for sure and I just barely broke the edge. I think on down the road I will send for the CORRECT one and try it again.

(http://i236.photobucket.com/albums/ff100/Intercooler2/20130812_191947_zpsb07b2ae7.jpg)
Title: Re: Dan Wesson Razorback flat bottom block install round 2
Post by: sqlbullet on August 13 2013 11:39:46 AM MDT
Wrong one in that it was a series 80 stop?  No issues putting one in a series 70 gun, other than you possibly have a nook that can fill with crud.
Title: Re: Dan Wesson Razorback flat bottom block install round 2
Post by: Intercooler on August 13 2013 03:25:50 PM MDT
Yea. They are cheap so I will order another one in another month or two.
Text only | Text with Images