I ordered four 10mm K10 mags off of GunBroker and they arrived today. I received two with the Mec-Gar thin base pads and two with the Tanfoglio base pads. I guess like a Lady with her clothes, I can swap to achieve the desired look ;D
(https://sphotos-b-atl.xx.fbcdn.net/hphotos-ash4/1234413_577757972262239_581588593_n.jpg)
(https://fbcdn-sphotos-d-a.akamaihd.net/hphotos-ak-ash4/1240003_577758385595531_401994435_n.jpg)
It was a good price and I know they function 100%!
Also got the elusive 9mm 6" barrel to use in my Hunter 10mm upper. The guys on the Enos Forum said it will work but I just tried it and NOPE! It must need some filing somewhere to go into battery correctly. I measured all the dimensions out and other than the necking down for the chamber size they are identical.
(https://fbcdn-sphotos-b-a.akamaihd.net/hphotos-ak-ash4/1233410_577759592262077_906983568_n.jpg)
Polygonal rifling too
(https://sphotos-b-atl.xx.fbcdn.net/hphotos-prn2/1239622_577759782262058_548627032_n.jpg)
With it assembled correctly I get this ???
(https://fbcdn-sphotos-d-a.akamaihd.net/hphotos-ak-prn2/1234069_577793452258691_1900467101_n.jpg)
Oh Ooo! Slide not fully in battery? ??? What's up with that?
After pulling my hair out and swapping tops over and over seeing what was going on.... their is a pad at the top (didn't take a pre photo) that has to be filed to fit barrel movement. Here is the area at the top after I filed for an hour until it would unlock correctly.
(https://sphotos-a-atl.xx.fbcdn.net/hphotos-ash3/944793_577848932253143_1879069016_n.jpg)
Finished product ready to rock the 9mm 6" tomorrow
(https://sphotos-a-atl.xx.fbcdn.net/hphotos-frc3/1173812_577849252253111_115053346_n.jpg)
(https://sphotos-a-atl.xx.fbcdn.net/hphotos-frc1/1236112_577849078919795_650994165_n.jpg)
When I got my 6 inch 10mm barrel I had to do just a little filing to make it fit right. It was worth it in the long run.
Now that they are $321 for sure :o