I have worked hard on this and I am going to post it somehow w/o spending another 90 minutes retyping it again. I am going to try to attach the works doc and see what happens
[attachment deleted by admin]
I understand about the copy and paste not working very easy for this.
BTW I did read your report (opened it using MS Word) and you finds are very simular to what I and others have seen.
About the Cast thru thru the Glock, I do run my own cast thru my G-29 and they are just wheel weight hardness or maybe slightly harder. However bullet fit in the bore and lube are the most important part of that equasion. Using the LEE FCD or even other taper crimp dies can squeeze down the bullet during crimping and that can cause leading issues by making the bullet too small! If you choose to shoot lead alloy in you Glock just inspect it and clean it if necessary and you should be good to go!
thanks for the report
Shadow,thanks for the comments re using lead in glock barrel. I think I will stick to fmj with stock barrel and send the L/W barrel back and get it opened-up and use lead in it.
How do we view the file?
Quote from: Intercooler on July 11 2012 04:44:48 PM MDT
How do we view the file?
Look at this thread (http://10mm-firearms.com/range-reports/range-report-in-word/). The OP put it up as a word doc, and I stripped out all the offending characters and put it in my post as a quote.
As long as you have word on your computer, simply dbl click the link..
Its odd copy past dosen't work here... Unfortunate too as it is how I compose longer (thought out) posts...
CW
Copy/paste works fine. Some special characters don't, like the curly quotes that Word automagically puts in if you put type plain double quotes.
Quote from: sqlbullet on July 23 2012 09:50:30 AM MDT
Copy/paste works fine. Some special characters don't, like the curly quotes that Word automagically puts in if you put type plain double quotes.
I cannot copy text form word and past here. All that shows is first couple words...
I have been able to "quote" just fine..
CW