Great score!!!

I recently picked up a new 6" Python. I'd say thumbs up. I had an 8" Python back in the day. Trigger is smooth and the fit/finish is incredible with ~25 rounds sent downrange. I won't mess with the trigger.

Im in a similar situation. No SPP to be found but I have plenty of LPP so I am loading 10mm, .45ACP and 45colt. for the time being.....

My wife says I have too many hobbies. She's probably right.

Loaded 300 rounds of 180gr jacketed flat points over 10.0 gr Blue dot

I have just prepped a pile of 10mm cases and about ready to reload with 180 gr jacketed flat points over 10gr blue dot. Thank you!!

It's interesting about the use of small primers for 10mm. For handloaders like us, it's an inconvenience.

I have a 20 year old Dillon 550 B (converted the C last year). This was after selling my RCBS ammomaster that I owned for ~10 years. Dillon and RCBS support have been 100% excellent in my many years of experience.
If you go progressive, I highly suggest the mind set of taking your time vs going as fast as you can. This goes for caliber changes/switching primer size. There is a lot going on with each throw of the handle and all it takes is a hiccup on primer feed to stop one in their tracks. Triple check the powder feed/charge weight before going full production and I like using a separate crimp die in the 4th station.

I have shot 40s without issue in my DE. It was a mistake as I did not look close enough when packing for the range trip. Not alot of rounds ~25. Have not tried this in any other 10mms in my collection.

OP, it's interesting about the results on the Xtreme plated bullets. Years ago I loaded some plated bullets and I think were over crimped. I swear, they were coming out of my Delta Elite barrel sideways, keyholes in my target at 10yds like a shotgun pattern (don't recall what the load was.....). I read an article in blue press about going with minimal crimp and have been mindful of this ever since but w 10mm I switched to jacketed bullets only. After reading your post, I will be open to try plated again. It would be interesting to see how plated compares to polymer coated.

Dan Wesson also chambered the Commander Classic Bobtail in 10mm (listed on Gunbroker  .

Uberti Cattleman

10mm brass w small primer pockets? I have never heard of this. Sort of like 45 Gap, I guess(?).

Hey Guys,
I spent some time shooting the Uberti side by side with the SW610 (handloads). In summary, the Uberti is a shooter. POI is a bit high and to the left. It will be interesting to get more range time to see how/if it changes with various loads. The 610 feels comparable but with better sights and smoother S/A trigger pull. Obviously huge difference in the grips between the two which makes for kind of a tough compare.

Thanks guys,
Flash can is definitely a possibility. Now I just find to find one in 10mm w 5/8-24 thread. Hopefully I can find one that will fit partially recessed in the handgaurd. This why I have been looking for a brake that will potentially be easier to get a wrench on it.