So I now have 400 Starline cases and that I have formed, loaded and shot. It's time to reload them. I am using a Dillon 550 and the 9 x 25 die set, with a Lyman M die which worked great for the first loading's. Any pitfalls to be aware of with these as I reload them? 

Does any one have any advice on a starting point with a 95 grain cast bullet? I usually use Longshot , but also load 10 mm with Blue dot and BE-86. I will cast these 75-25 Linotype /lead and water quench before powder coating. 

Hi everyone,

The h&g 275 NLG clones that I posted a picture of shoot very well . Worked up to 10.6 grains of Longshot with out any pressure signs and made beautiful rounds holes with the SWC .

Nice , glad you don't have a real street sweeper, bad design. I have a fn slp 22 in. 8=1 semiauto. that I love.

3 barrels in stock for Glock's at Barsto now.

[attachment deleted by admin]

Has anyone anealed their brass?

Good to know

Excellent,. That will help keep the cost down a little.

Does anyone have any experience with Montana Gold 357 sig bullets?
Also I have a new mold: 
That I would love to cast some pure linotype boolits with. It is a HG 275 clone 130 gr SWC.  I think they will hold together. In 9mm they are very accurate.


[attachment deleted by admin]

Quote from: The_Shadow on May 12 2018 06:06:58 PM MDT
The 4 gen may be OK because the impulse of the 9x25 is different than the 10mm full power loads.
However I run the Non-Captive 22 lbs on the S&W 1006 and Glock 20SF and the 21 lbs dual springs on my G-29 for everything 40S&W, 357Sig and 9x25's.

I have a lone wolf tungsten Guide rod and the 17 lb and the 22 lb springs ( gen 3 with adapter) for my Gen 4 G20. I have not used the 22 lb spring yet. Waiting for my 9 x 25  Bar sto barrel  to be fitted to try it out. Does anyone have this setup for a gen 4?   

I got my barrel finally,. It is being fitted by a gunsmith I trust. Also bought a coupe of boxes of Underwood 124gr fmj. Can't wait to try it out.

Barsto has the 9 x 25  Dillon listed as an option now on their website for the Glock model 20

 

[attachment deleted by admin]

"I use a KKM factory length with my gen 4 model 20 with better accuracy and no issues. 

Thanks everyone, received my KKM 10 MM barrel and it is a sweetie. i shoot tighter groups and no Glock smile or bulge. Will be ordering my 9 x 25 barrel soon. 

Both Barsto and KKM replied and said they would make one. Barsto is quicker , but more expensive. I am ordering a 10 mm from KKM first in the next week or so. The gen 4 factory barrel is better than earlier barrels I have seen,  but still produce a bulge. I am used to that with .40 and have a Redding G-Rx die that I use. And I cast/PC my own bullets.  Are the Barsto barrels worth the extra money?