The SC is just the .327 magnum rimmed in a rimless form factor. Once you look harder at the ballistics the advantages become clear. If I could get a classic P series in a 30 SC, I would

Quote from: Mike D on September 15 2022 10:45:55 PM MDT

Quote from: challer61 on September 15 2022 12:34:10 PM MDT
With Mark no longer taking work, where would you suggest? I have a 610, spare cylinder. Want an action job, second cylinder fitted and reamed

Where did you hear Mark isn?t taking any more work?


Sent from my iPhone using Tapatalk Pro

He told me. At least isn't taking my work.

Get the Single Seven in 327

What 10mm carbine do you have? Do you think an APC10 with brace would pass?

With Mark no longer taking work, where would you suggest? I have a 610, spare cylinder. Want an action job, second cylinder fitted and reamed

I see gauges popping up and dies will eventually come out. Problem is FK wants to make the money on the ammo more than the gun and so have not applied for SAAMI. It's basically a 9x30 Dillon but with a 7.62 bullet. I like 9x25 Dillion and am looking to have a barrel cut for it as well as 9x30. It shoots with Authority and hog kills at 100yds with it are a thing. If a B&T APC pro were in this cartridge, I'd be all over it.

They have no desire to make things work. They need shootings to rally the base and chip away at another piece of the iceberg. Everyone is telling themselves it?s not as bad as it could?ve been. And 50 years of that got us to this.

Virginia and many other states require a 4473 in all transfers, even to family

A mental health test

Look forward to your range report. If they come out with an AXG grip and Barsto supports them, I may consider

Well, I went in for a Glock 40 after two years of waiting. More waiting before it's out.

If they come out with the AXG metal grip for it, and Bar-sto supports it, I may have to ditch the Glock.

I have the Swift A-Frame ammo. So far so good on pigs.

I have a lot of Wiha tools and they are some of my best. Recently, I had to replace the from site on my G40. I went though a couple different tools (not wiha) and the wall thickness was too much to fit into the recess of the front site nut. Finally went with the Glock factory site tool and it worked perfectly. I hope the Wiha works; most of the others would have required filing to get them to work

The SRO on mine mounted without a plate. Just remember to use the recoil pins. They are only just briefly mentioned in the manual

I use the F9 for hunting. But go to YT and the other rounds on game are demonstrated