I was looking for the section where people post up recepies. I do have a question for the discussion of equipment though... How do you guys have your dies set up? I have mine set up so that the Lee Decap/Resize die only resizes about a 1/4" of the case mouth and I use the FCD to streighten the wall and light crimp the tip into place. I mention this only because the rounds seem to come out better when I do it this way imho, and everything done when reloading has an affect on the final product. Of coarse since I use aftermarket and tight chambered barrels in all of my firearms my brass does not buldge as much and is therefore resized signifigantly less and has lasted longer for me, but I have tenth generation full power reloads that I feel I would not have had, had I not switched to the die set up I have now.