Sizing Dies

[EdMc]

I just finished preping 1K of various brands of used brass (FC, NORMA, Winchester, Hornady, HMR) Seperated by make.
First all were polished in corncob media, little lighter fluid and cut up dryer sheets.

Okay, you got me. I've never heard of using lighter fluid and 'Bounce' sheets?

[The_Shadow]

The lighter fluid (charcoal lighterI is a solvent with low evaporation below 100 degrees to clean the soot and actually helps polishing, maybe a tea spoon in small tumbler.  The dryer sheets(used, I use two sheets cut in 1" squares) these actually clean the media as they collect and hold the dust and dirt.  Life is good! 

[sqlbullet]

+1 for dryer sheets.  Just cut them into little squares.

[REDLINE]

Tips and tricks from the pros.  Couldn't get any better than that.

[Yondering]

Strips of paper towel works too (in place of dryer sheets).